The APW3++ AC-DC Power supply is specifically designed with mining operations in mind, and combines high conversion efficiency and a strong dynamic performance into a power dense package. It also features short circuit, overload, overheat, low voltage and overload protections.
This Power supply includes several features which make it optimal for cryptocurrency mining operations, including:
1) The air flow direction runs from the AC input to the DC output, which is the same configuration as most miners. This proves beneficial for those with large-scale mining operations where heat management is a major consideration.
2) The PCB uses a conformal coating to prevent damage from high voltage spark discharges on MOS pins, or near high-pressure solder joints when external conductive particles or dust enter the PSU.
The APW3++ can deliver a maximum power of only 1200W if it is connected to a 110V (US) mains power supply. To obtain the rated power of 1600W, the APW3++ must be connected to a 220-240V (ROTW) mains power supply. Please check the mains power supply that is the standard in your region before ordering.
The PSU comes with only 10 PCIe connectors so it should not be used with more than one Antminer L3+ miner.
DC Voltage: 12.15V
(220V input): 133A
(110V input:) 100A
(220V input): 1600W
(110V input): 1200W
Ripple & Noise: <1%
Voltage Regulation: <2%
Source Regulation: <1%
Load Regulation: <1%
Setup, Rise Time: <2S
Power off Protection Trip Time: >9mS
Interface Type: 5 pairs of 6 pin PCI-E connectors (i.e. 10 connectors)
Noise Level: <43DB
Voltage Range: 100-240V AC
Starting Voltage: 95-105V AC
Frequency Range: 47-63Hz
Power Factor: >0.95 (full load)
Leakage Current: <1.5mA (220V 50Hz)
Low-voltage Input: 80-89V AC
Output Short Circuit: Yes
Output Overcurrent: 134-185A max.
Overheat Protection: Yes
Operating Temperature: -20°C – 50°C
Operating Humidity: 20% – 90% relative humidity (non-condensing)
Fan: Forced-air cooling